|
Maintaining a plumbing system in your home can be a tedious task. Regular maintenance can prevent major plumbing issues and save you from expensive repairing costs in the future. A resource you can trust is this plumbing company in Dallas. Here are some tips for regular maintenance of plumbing systems: 1 on the plumbing maintenance checklist – Preventing a burst pipeIf you’re concerned about a plumbing leak, you should put “preventing a burst pipe” on your plumbing maintenance checklist. When subzero temperatures hit, water pipes are vulnerable to becoming raging geysers. Water expands as it cools, but pipes carrying it do not expand. If you’re not a handyman, you can’t even tell if your water pipes have burst because they’re frozen! Even worse, these pipe problems can happen overnight, while you’re away. 2 on the plumbing maintenance checkliist – Checking for leaksChecking for leaks is one of the most important tasks you should perform on your home’s plumbing system. Leaky pipes can cause a wide range of problems, from structural damage to mold problems. The water lost from a leaky home can result in a costly water bill. Leaks can also cause extensive water damage to your home. In addition to being an eyesore, leaking pipes can cause serious damage to the foundation of your home. 3 on the plumbing maintenance checklist – Checking for deterioration around boltsSlow drains are a warning sign that your plumbing is deteriorating. A buildup can form around the bolts and gasket, causing a leak in the tank. Eventually, years of use will cause cracks and corrosion in the pipes. Cracks and corrosion can also be spotted around faucets and bolts, especially in areas with high levels of moisture. If you notice any of these signs, it’s probably time to get your plumbing system repaired or replaced. 4 on the plumbing maintenance checklist – Checking for water pressureOne of the most important items to check on your plumbing maintenance checklist is water pressure. Low water pressure slows down basic plumbing tasks and puts the stability of your plumbing system at risk. Normal water pressure should be around 60 pounds per square inch. Anything below that amount requires corrective measures to ensure that water pressure is safe. To test the water pressure in your home, use a pressure gauge. If it is too high, you may want to consider installing a pressure regulator. 5 on the plumbing maintenance checklist – Checking for clogged drainsIf you have a sink or bathtub that doesn’t drain properly, check your pipes for clogs. A slow drain can be a sign that a pipe has backup and should be cleaned out. This will prevent water from accumulating and pose a health risk, and it will also cost you money in high utility bills. To prevent a drain clog, use a drain cleaner, but keep in mind that liquid drain cleaners can damage PVC pipes. Always remember that drains in the kitchen need special attention. 6 on the plumbing maintenance checklist – Checking for backflow prevention devicesOne of the most important tasks on your plumbing maintenance checklist should be checking for backflow prevention devices. These devices prevent the backflow of potentially hazardous water into your clean water supply. In most cases, backflow prevention devices are required in commercial plumbing systems. They prevent water leaking from dirty plumbing systems to clean ones and protect your water supply. However, they must be installed properly and tested annually. Failure to install a backflow prevention device can lead to fines and shut off of your water supply. Your source in Dallas: https://www.rodgersplumbing.com |
